3D Printed RC Car using GT2 Belt

Hello there, these are all the components you need to prepare before building this RC car.

Hardware Components :

For 3D printing parts, you can download them from Cults3D.

• 65 mm wheels x 4
• Hex coupler x 4
• F684ZZ Bearing x 4
• 25T Servo Arm
• Pushrod 2x200mm with M2 thread at the end ( cut into 2 pieces )
• Ball joint M2
• Shaft 4mmx150mm
• Pulley GT2 20T ( Shaft 6 mm)
• Pulley GT2 32T ( Shaft 4mm)
• GT2 Belt 188mm
• Propeller Adapter
• Electronic Scew Driver
• Bearing 624zz X4
• M3x45 mm with nuts
• M3 Screw set

Electronics Components:

• Dumbo RC X6 + RX P6FG
• Brushless motor A2217-1250KV ( diameter 4)
• 3S Lipo Battery ( XT 60 Jack)
• ESC 40A brushless motor
• Lipo Charger
• MG996R Metal geared Servo

This post may contain affiliate links. If you purchase through these links, I may earn a small commission at no extra cost to you. It helps support this blog and keeps the projects coming—thanks for your support!